Make the stationary vehicle model of your choice fit for Car System. Chassis kit to motorize stationary models of buses and trucks for Car System operation.
Set contains all vehicle components required for the assembly of a fully functioning two-axle Car System H0 chassis (bus and truck), except the rechargeable batteries: support PCB, motor with worm, motor holder with worm wheel and driving axle, driving wheels, front axle with wheels, steering rod with magnet, front axle holder, switch, charging socket, dry-reed sensor, resistors to adjust the charging current and driving speed.
Conversion info:
- Axle base can be selected continuously between 38 mm and 88 mm
- Width: 29 mm
- Support PCB with all electrical connections required for easy soldering of components, incl. soldering pads for warning beacons
- Fastening of motor and gear unit at choice horizontal (e.g. in buses and trucks with dropped frame) or vertical (e.g. in semitrailer trucks)
- Built-in HERPA standard crossmember can be removed when using any bodywork of other manufacturers
This vehicle is fitted with a powered chassis and a steering front axle. The axle is fitted with a small magnet which follows the guide wire embedded in the baseboard. The batteries installed in the vehicle are re-chargeable so just need plugging in to the Battery Charger (Sold Separately) when the vehicle runs out of power. A great way to add extra realism to your railway.
